View all text of Subpart CC [§ 98.290 - § 98.298]
§ 98.296 - Data reporting requirements.
In addition to the information required by § 98.3(c), each annual report must contain the information specified in paragraphs (a) or (b) of this section, as appropriate for each soda ash manufacturing facility.
(a) If a CEMS is used to measure CO
(1) Annual consumption of trona or liquid alkaline feedstock for each manufacturing line (tons).
(2) Annual production of soda ash for each manufacturing line (tons).
(3) Annual production capacity of soda ash for each manufacturing line (tons).
(4) Identification number of each manufacturing line.
(b) If a CEMS is not used to measure CO
(1) Identification number of each manufacturing line.
(2) Annual process CO
(3) Annual production of soda ash for each manufacturing line (tons).
(4) Annual production capacity of soda ash for each manufacturing line (tons).
(5)-(7) [Reserved]
(8) Whether CO
(9) Number of manufacturing lines located used to produce soda ash.
(10) If you produce soda ash using the liquid alkaline feedstock process and use the site-specific emission factor method (§ 98.293(b)(3)) to estimate emissions then you must report the following relevant information for each manufacturing line or stack:
(i) Stack gas volumetric flow rate during performance test (dscfm).
(ii) Hourly CO
(iii) CO
(iv) CO
(v) Average process vent flow from mine water stripper/evaporator during performance test (pounds/hour).
(vi) Annual process vent flow rate from mine water stripper/evaporator (thousand pounds/hour).
(11) Number of times missing data procedures were used and for which parameter as specified in this paragraph (b)(11):
(i) Trona or soda ash (number of months).
(ii) Inorganic carbon contents of trona or soda ash (weeks).
(iii) Process vent flow rate from mine water stripper/evaporator (number of months).